مركز هانى ناشيونال للالكترونيات وصيانه الشاشات
هل تريد التفاعل مع هذه المساهمة؟ كل ما عليك هو إنشاء حساب جديد ببضع خطوات أو تسجيل الدخول للمتابعة.


LED/LCD/PLASMA/SMART/3D/TFT/LEOD TV Repair
 
الرئيسيةالرئيسية  البدايةالبداية  أحدث الصورأحدث الصور  التسجيلالتسجيل  دخول  

 

 Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV

اذهب الى الأسفل 
2 مشترك
كاتب الموضوعرسالة
hany_national
هانى النجار Professional Technician
hany_national


عدد المساهمات : 2115
تاريخ التسجيل : 14/11/2009
العمر : 45
الموقع : Egypt.Alexzandria

Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV Empty
مُساهمةموضوع: Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV   Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV Emptyالثلاثاء 19 يوليو 2011 - 1:51

Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV




Symptom: VGA Input “NO SIGNAL”
Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV LCDHISENSE



When testing this LCD TV, all other input were found to be good except the VGA input. When plug in the VGA connector to this LCD TV from desktop computer or even laptop the result were the same- “NO SIGNAL” error message shown on the screen.

This LCD TV was used in the shopping mall for displaying content purpose. Since it is a display set in a shopping mall, the customers and the staff always plug and unplug the VGA connector without turning the power off causing the above error to appear. Others input of this LCD TV was not affected except the VGA input.

The troubleshooting will be on the VGA input circuit and below is the VGA input signal diagram
Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV LCD%20HISENSE%20SCHEMATIC


R, G and B lines open circuit will not cause the above symptom except if there is component shorted. If the HS or VS line (VGA connector pin 13 & 14) have an open circuit the above symptom will appear because no signal from the CPU could pass through. In this LCD TV, I found a resistor (R103-100ohm) that is located in series with the HS line had an open circuit. The problem now was that the error message did not go away even the SMD resistor (R103) was replaced.

I continued to check on the components that is corresponding to the R, G and B line (pin 1, 2 and 3 of the VGA connector) and found Z7, Z8 and Z9 were shorted. Those SMD resistors R98, R99 & R100 (all 75 ohm) that is connected from the R,G and B line to ground were open circuit too.

Components located in the pin 11, 12, 15 (VGA-SDA, DDC-SDA & DDC-SCL) were found to be good. This LCD TV was brought back to life again after the components were replaced.

Below is the picture where the defective components were located.
Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV LCDTVBOARD
الرجوع الى أعلى الصفحة اذهب الى الأسفل
salah

salah


عدد المساهمات : 4
تاريخ التسجيل : 18/05/2012

Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV Empty
مُساهمةموضوع: رد: Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV   Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV Emptyالسبت 19 مايو 2012 - 0:52

شكرا على الموضوع
الرجوع الى أعلى الصفحة اذهب الى الأسفل
 
Troubleshooting "No Signal" Symptom In Hisense TLM55V88GP LCD TV
الرجوع الى أعلى الصفحة 
صفحة 1 من اصل 1
 مواضيع مماثلة
-
» DUMP Hisense LEDN32A300J,Hisense LEDN30D20
» Repair DVD With The Symptom Of "No Disc"
» LG 42PC5DC Plasma TV Switch Mode Power Supply Operation and Troubleshooting
» How To Repair Dell E152Fpb LCD Monitor With No Display Symptom
» HISENSE LEDN55K370GPV

صلاحيات هذا المنتدى:لاتستطيع الرد على المواضيع في هذا المنتدى
مركز هانى ناشيونال للالكترونيات وصيانه الشاشات  :: صيانة شاشات LCD و البلازما والكرستال السائل-
انتقل الى: